INEOS Grenadier Build Guide: Racks, Storage, Comms and Fridge

The full size Slimline II tray runs 2570 mm (101.2 in) from windshield to rear door. The kit includes a wind deflector, 8 gutter mount legs and the Grenadier grab handle brackets, and it installs with no drilling. Front Runner lists it for the 2022 and newer Grenadier.

The 3/4 kit uses a 1964 mm (77.3 in) Slimline II tray on 6 gutter mount legs plus the grab handle brackets, with a wind deflector and no drilling. It leaves part of the roof open. Front Runner lists it for the 2022 and newer Grenadier.

The Slimline 3 tray is 1560 mm (61.4 in) wide and 2744 mm (108 in) long and sits at 60 mm (2.4 in) or 90 mm (3.5 in). Front Runner says the tray design is 20% lower than the Slimline II. Each slat has dual T-slot channels, all four corners carry tie-down points, and the side profiles hide accessory wiring. It mounts with the included Grenadier mounting system (MSIG001).

The 3/4 Slimline 3 tray is 1560 mm (61.4 in) wide and 1936 mm (76.2 in) long with the same 60 mm or 90 mm height settings, dual T-slot slats and corner tie-downs. It mounts with the included Grenadier 3/4 mounting system (MSIG003).

A full cab length Slimline II tray, 1560 mm (61.4 in) long, on 8 gutter mount legs with a wind deflector. It installs with no drilling.

A 954 mm (37.6 in) Slimline II tray over the front of the cab on 6 gutter mount legs, with a wind deflector and no drilling. Front Runner sizes it for a light bar, a pair of recovery boards or a small cargo box.

A 1475 mm by 1358 mm Slimline II tray on 6 extra tall legs that fit the factory bed tracks, so the bed stays usable under the rack. No drilling is needed.

The same 1475 mm by 1358 mm tray on 6 flat 65 mm feet for a Quartermaster with a roller tonneau cover, so the cover stays in place.

A 4 step ladder that bolts to the factory mounting points on the rear door and gives a steady climb to the roof rack. It is rated to 110 kg (242.5 lb) and weighs 4.62 kg (10.2 lb). Front Runner lists it for the 2022 and newer Grenadier.

The table mounts inside the rear swing door and folds down into a work surface. A primary and a secondary tray drop when you release the latch, and the main tray slides out a bamboo extension for 445 mm (17.5 in) more length. Closed, the molle face takes strapped gear. Front Runner lists it for the 2022 and newer Grenadier. On backorder from Front Runner. It ships when the maker restocks it.

A second storage level that secures to the load bay tie down points with no drilling. Height adjusts from 480 mm to 630 mm in 30 mm steps, so it can sit low over a fridge or high over taller boxes. Six L-track points hold gear on top, and the molle underside takes strapped gear. Front Runner lists it for the 2022 and newer Grenadier.

A powder coated frame and top deck that holds Front Runner Wolf Pack Pro boxes in the load bay. The frame is spring loaded so the boxes do not rattle, and the top deck carries 80 kg (176.4 lb) and can take a Front Runner cargo or fridge slide. It bolts to the factory mounting points. On backorder from Front Runner. It ships when the maker restocks it.

A pair of low profile steel panels that contour to the factory paneling and turn the rear side windows into storage walls. They shield the glass from cargo that shifts on rough trails and accept the Rago shelves and molle accessories. Rago lists them for the 2023 to 2026 Grenadier and makes them in the USA.

Steel shelves that bolt to the Rago Rear Window Molle Panels and add shelf space above the cargo floor for bags, blankets and pillows. The Standard shelf mounts in the mid and lower zones of the window panels and the High-Mount shelf at the top; you can run one or both. Rago lists them for the 2023 to 2026 Grenadier and makes them in the USA.

Steel panels that contour to the factory center console and put radios, phones, tablets and GPS units within reach of the driver. They carry 10-24 pre-threaded mounting points and are RAM mount compatible. Rago lists them for the 2023 to 2026 Grenadier and Quartermaster.

A complete GMRS kit built around the Grenadier interior: a mobile radio, a Grenadier radio mount, a Grenadier antenna mount placed to clear roof racks and rooftop tents, and a Rugged GMRS tuned antenna on 13 ft of coax with a nickel plated brass NMO mount. Choose the waterproof GMR25 at $443, the 50 watt Rambler G4 at $508 or the waterproof G1 at $590. Rugged Radios lists it for the 2022 and newer Grenadier, all trims.

If you already own a radio, this mount puts it on the passenger side of the center console using the factory mounting holes, with no drilling or cutting. It works with Rugged radios such as the GMR25, GMR45, M1, G1 and G4, and with other radios through the universal slots for a factory U-bracket.

A 55L single zone fridge freezer with a built in ice maker. It holds up to 84 12 oz cans, cools from -7F to 68F and draws 8.5A at 12V. It measures 28.35 x 17.91 x 18.9 in and weighs 44.44 lb. With the Dometic protective cover it is $1,369.98.

A 75L dual zone fridge freezer, so you can run a fridge and a freezer at once. It holds up to 113 12 oz cans, cools from -7F to 68F and draws 9.7A at 12V. It measures 35.12 x 19.49 x 18.58 in and weighs 59.62 lb. With the Dometic protective cover it is $1,539.98.